LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> 6 Mazdaspeed >> Repair and Diagnosis >> External Pages >> Different car >> Section 653 (Basic System (HVAC)) >> Airflow Mode Main Link Removal/Installation >> Notes

Airflow Mode Main Link Removal/Installation: Notes

WARNING: This page is about a different car, the 2007 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Detach the hood release lever from the lower panel. (See HOOD LATCH AND RELEASE LEVER REMOVAL/INSTALLATION .)
  3. Remove the front scuff plate (LH). (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
  4. Remove the front side trim (LH). (See FRONT SIDE TRIM REMOVAL/INSTALLATION .)
  5. Remove the lower panel. (See LOWER PANEL REMOVAL/INSTALLATION .)
  6. Remove the shower duct (LH).
  7. Remove the airflow mode actuator, (full-auto air conditioner) (See AIRFLOW MODE ACTUATOR REMOVAL/INSTALLATION .)
  8. Disconnect the airflow mode wire, (manual air conditioner) (See CLIMATE CONTROL UNIT REMOVAL [MANUAL AIR CONDITIONER] .)
  9. Remove the airflow mode rod.
  10. Remove the airflow mode main link.
  11. Install in the reverse order of removal.
  12. Adjust the airflow mode wire, (manual air conditioner) (See CLIMATE CONTROL UNIT WIRE ADJUSTMENT .)
    Fig 1: Identifying Airflow Mode Main Link
    G04956307Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals