LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> 6 Mazdaspeed >> Repair and Diagnosis >> External Pages >> Different car >> Section 611 (Security System And Locks System (Keyless Entry System)) >> Keyless Control Module Removal/Installation[Keyless Entry System]

Keyless Control Module Removal/Installation[Keyless Entry System]

WARNING: This page is about a different car, the 2007 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  2. Remove the side panel. (See SIDE PANEL REMOVAL/INSTALLATION .)
  3. Remove the bolt and nut.
  4. While inclining the keyless control module along the body panel in the direction indicated by the arrow, disengage the bracket tab from the hole in the body panel.
  5. Disconnect the keyless control module connector.
  6. Remove the keyless control module.
    Fig 1: Disengaging Bracket Tab
    G04931341Courtesy of MAZDA MOTORS CORP.
  7. Remove the screw, then remove the bracket.
    NOTE:
    • The screw which fixes the keyless control module and bracket is for a body ground connection. Be sure to secure the screw when installing.
  8. Install in the reverse order of removal.
Fig 2: Removing Bracket & Screw
G04931342Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals