LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> 6 Mazdaspeed >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic [Engine Control System L3 With TC] >> On-Board Diagnostic Test >> PID/DATA Monitor and Record Procedure

PID/DATA Monitor and Record Procedure

NOTE: The PID/DATA MONITOR function monitors the calculated value of the input/output signals the PCM. Therefore, an output device malfunction is not directly indicated as a malfunction of the monitored value for the output device. If a monitored value of an output device is out of specification, inspect the monitored value of the input device related to the output control.
  1. Connect the M-MDS to the DLC-2.
  2. After the vehicle is identified, select the following items from the initial screen of the M-MDS.
    • When using the IDS (laptop PC)
      1. Select the "Toolbox" tab.
      2. Select "Datalogger".
      3. Select "Modules".
      4. Select "PCM".
    • When using the PDS (Pocket PC)
      1. Select "Module Tests".
      2. Select "PCM".
      3. Select "Datalogger".
  3. Select PID from the PID table.
    Fig 1: Locating DLC-2 Connector
    G04324072Courtesy of MAZDA MOTORS CORP.
  4. Verify the PID data according to the directions on the screen.
scientia non olet · About LEMON Manuals