LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> 6 Mazdaspeed >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic [Engine Control System L3 With TC] >> On-Board Diagnostic Test >> On-Board System Readiness Tests Access Procedure

On-Board System Readiness Tests Access Procedure

  1. Connect the M-MDS to the DLC-2.
  2. After the vehicle is identified, select the following items from the initial screen of the M-MDS.
    • When using the IDS (laptop PC)
      1. Select the "Toolbox" tab.
      2. Select "Powertrain".
      3. Select "OBD Test Modes".
      4. Select "Mode 1 Powertrain Data".
    • When using the PDS (Pocket PC)
      1. Select "OBDII Modes".
      2. Select "Mode 1 Powertrain Data".
      3. Select "PCM".
  3. Then, select the "***SUP" and "***EVAL" PIDs in the PID selection screen.
    Fig 1: Locating DLC-2 Connector
    G04324072Courtesy of MAZDA MOTORS CORP.
  4. Monitor those PIDs and check if system monitor is completed.
scientia non olet · About LEMON Manuals