Diagnostic Monitoring Test Results

The purpose of this test mode is to confirm the result of the OBD-II monitor diagnostic test results. The result values stored when a particular monitor is completed are displayed. If the monitor is not completed, the initial value is displayed.

DIAGNOSTIC MONITORING TEST RESULTS

TEST ID

Description

Related system

10:01:80

HO2S (Front) lean-to-rich response time (calculated)

HO2S

10: 02: 03

Low HO2S (Rear) voltage for switch time calculation (constant)

10:02:04

High HO2S (Rear) voltage for switch time calculation (constant)

10:02:05

HO2S (Rear) rich-to-lean response time (calculated)

10:21:80

Front and HO2S (Rear) switching time ratio

Catalyst

10:31:83

EGR pressure variation

EGR

10:3A:80

EVAP system leak detection pump gross leak check

EVAP

10:3B:80

EVAP system leak detection pump small leak check

10:3C:80⁽¹⁾

EVAP system leak detection pump very small leak check

10:3D:80

Purge flow monitor

10:A2:0B

EWMA misfire counts for last 10 driving cycles

Misfire

10:A2:0C