Passenger's Side
- Measure the voltage at each terminal (other than terminals I and H).
- If the voltage is not as specified in the Terminal Voltage Table, inspect the parts under "Inspection item(s)" and related wiring harnesses.
- Disconnect the negative battery cable.
- Inspect the power window subswitch connector for continuity at terminals I and H.
- If the system does not work properly even though the inspection items or related wiring harnesses do not have any malfunction, replace the power window subswitch.
Terminal Voltage Table
TERMINAL VOLTAGE LIST
| Terminal | Signal name | Connected to | Measured condition | Voltage (V)/Continuity | Inspection item(s) |
|---|---|---|---|---|---|
| A | Power-cut signal | Power window main switch | Ignition switch at ON and power-cut switch at UNLOCK | B+ |
|
| B | Open output | Power window motor | While door glass is opening | B+ |
|
| While door glass is closing | 1.0 or less | ||||
| C | Pulse 1 | Power window motor | Door glass moving | Alternates between 1.0 or less and B+ |
|
| Door glass stopped | 1.0 or less or B+ | ||||
| D | Power supply | P.WIND 30 A fuse | Under any condition | B+ |
|
| F | Pulse 2 | Power window motor | Door glass moving | Alternates between 1.0 or less and B+. |
|
| Door glass stopped | 1.0 or less or B+ | ||||
| H | GND | Body ground | Under any condition: Inspect for continuity to ground. | Continuity detected |
|
| I | Sensor ground | Power window motor | Under any condition: Inspect for continuity to ground. | Continuity detected |
|
| J | Close output | Power window motor | While door glass is opening | 1.0 or less |
|
| While door glass is closing | B+ | ||||
| K | Power supply | Power window motor | Ignition switch at ON or during IG-OFF timer | B+ |
|
| L | Communication | Power window main switch | - | - | - |