DTC Inspection [Advanced Keyless System]: Notes

Connect the M-MDS to the vehicle DLC-2.
After the vehicle is identified, select the following items from the initial screen of the M-MDS.
- When using the IDS (laptop PC)
  1. Select the "Toolbox" tab.
  2. Select "Self Test".
  3. Select "Modules".
  4. Select "RKE".
- When using the PDS (Pocket PC)
  1. Select "Module Tests".
  2. Select "RKE".
  3. Select "Self Test".
Verify the DTC according to the directions on the screen.
- If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection.
Fig 1: Locating DLC-2 Connector
Courtesy of MAZDA MOTORS CORP.
Disconnect the M-MDS.