LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> 5 Touring, 2.3 L >> Repair and Diagnosis >> Electrical >> Horns >> Instrumentation/Driver Info >> Instrument Cluster Configuration

Instrument Cluster Configuration

NOTE:
  • If all the following conditions are met, the odometer data (total traveled, distance) in the previous instrument cluster is automatically transferred to a new instrument cluster during the configuration. If any of the conditions are not met, odometer-data transfer cannot be performed.
    • Previous Instrument Cluster 
      • No malfunction (Configuration data can be read using the M-MDS)
    • New Instrument Cluster 
      • Odometer display is less than 100 km
      • Odometer has no malfunction
  1. Connect the M-MDS or equivalent to the DLC-2.
    Fig 1: Identifying Data Link Connector (DLC-2)
    G04315948Courtesy of MAZDA MOTORS CORP.
  2. After the vehicle is identified, from the initial screen select the following items:
    • When using the IDS (laptop PC) 
      1. Select "Module Programming"
    • When using the PDS (Pocket PC) 
      1. Select "Programming"
      2. Select "Module Programming"
  3. Select "IC" and perform procedures according to directions on the M-MDS screen.
    • If odometer data is to be transferred to a new instrument cluster, perform the following procedure:
      1. Select "Programmable Parameters" from the menu.
      2. Select "Odometer Write", and perform the procedure following the screen.
      NOTE:
      • During the odometer data writing procedure, As-Built Data (VIN and Vehicle Data) input is requested. Obtain the As-Built Sheet for the vehicle, and input the necessary data.
  4. After the instrument cluster configuration, perform the wheel unit ID registration. (See WHEEL UNIT ID REGISTRATION ).
  5. Retrieve DTCs using the M-MDS and verify that there is no DTC present.
scientia non olet · About LEMON Manuals