LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> 5 Sport, 2.3 L, Standard >> Repair and Diagnosis >> Body & Frame >> Windows >> Glass/Windows/Mirrors >> Rear Power Window Regulator Removal/Installation

Rear Power Window Regulator Removal/Installation

  1. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [L3] ).
  2. Disconnect the negative battery cable.
  3. Remove the following parts:
    1. Remove the side door garnish. (See SIDE DOOR GARNISH REMOVAL/INSTALLATION ).
    2. Remove the rear side trim. (See REAR SIDE TRIM REMOVAL/INSTALLATION ).
    3. Sliding door trim (See SLIDING DOOR TRIM REMOVAL/INSTALLATION ).
    4. Sliding door glass (See SLIDING DOOR GLASS REMOVAL/INSTALLATION ).
    5. Rear power window motor (See POWER WINDOW MOTOR REMOVAL/INSTALLATION ).
  4. Remove the nuts.
    Fig 1: Power Window Motor Mounting Nut & Torque Specification
    G04317122Courtesy of MAZDA MOTORS CORP.
  5. Insert a hand through the service hole, rotate the drum housing in the direction shown in the figure and disengage the tabs from the sliding door module.
    Fig 2: Disengaging Tabs From Sliding Door Module
    G04317123Courtesy of MAZDA MOTORS CORP.
  6. Take the rear window regulator out through the service hole.
  7. Install in the reverse order of removal.
    CAUTION:
    • Make sure the cable does not unspool from the drum housing when installing.
      Fig 3: Locating Rear Window Regulator
      G04317124Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals