Power Window Motor Removal/Installation

Half open the door glass.
Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [L3] ).
Disconnect the negative battery cable.
Remove the following parts:
Front door
- Inner garnish (See INNER GARNISH REMOVAL/INSTALLATION ).
- Front door trim (See FRONT DOOR TRIM REMOVAL/INSTALLATION ).
Sliding door
- Side door garnish (See SIDE DOOR GARNISH REMOVAL/INSTALLATION ).
- Rear side trim (See REAR SIDE TRIM REMOVAL/INSTALLATION ).
- Sliding door trim (See SLIDING DOOR TRIM REMOVAL/INSTALLATION ).
Remove the bolts.
Remove the power window motor from the power window regulator drum.
Disconnect the power window motor connector.
Install in the reverse order of removal.

Fig 1: Power Window Motor & Torque Specification
Courtesy of MAZDA MOTORS CORP.
NOTE:
- When installing the power window motor to the power window regulator drum, the drum housing tabs may detach from the door module. If this happens, insert a hand through the service hole to engage the drum housing tabs, and install the power window motor to the drum while supporting the drum housing.