LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> 5 Grand Touring, 2.3 L >> Repair and Diagnosis >> Transmission >> Automatic Trans >> On-Board Diagnostic [Automatic Transaxle) >> PID/Data Monitor And Record Function Table

PID/Data Monitor And Record Function Table

PID/DATA MONITOR AND RECORD FUNCTION CHART

Monitor item (Definition) Unit/Condition Condition/Specification ACTION PCM terminal
DWN SW (Down switch) On/Off
  • M range, downshift: On
  • Other: Off
 Inspect the selector lever component.
(See SELECTOR LEVER COMPONENT INSPECTION ).		 1P
GEAR 1/2/3/4
  • 1GR: 1
  • 2GR: 2
  • 3GR: 3
  • 4GR: 4
 Inspect the following PIDs: SSA/SS1, SSB/SS2, SSC/SS3 N/A
HTM_CNT - Indicates number of high oil temperature mode (ATF temperature at 130 °C {266 °F} or more  ) operations
  • 0-255
 - -
HTM_DIS km Indicates travel distance after operation of high oil temperature mode (ATF temperature at 130 °C {266 °F} or more  )
  • 0-2550 km
 - -
LINEDES kPa in. Hg Indicates target line pressure Inspect the following PIDs
APR OSS, TFT, TFTV, THOP, TR, TR_SENS, TSS		 N/A
LPS
(Pressure control solenoid)		 A Change current value according to accelerator opening angle Inspect the pressure control solenoid.
(See SOLENOID VALVE INSPECTION ).		 1H 1G
MNL SW
(M range switch)		 On/Off
  • M range: On
  • Other: Off
 Inspect the selector lever component.
(See SELECTOR LEVER COMPONENT INSPECTION ).		 1O
OP_SW_B
(Oil pressure switch)		 On/Off
  • 1GR, 2GR or 3GR: On
  • Other: Off
 Inspect the oil pressure switch.
(See OIL PRESSURE SWITCH INSPECTION ).		 1L
OSS
(Output shaft speed)		 RPM Indicates output shaft speed
  • Ignition switch ON: 0 RPM 
  • Vehicle speed 25 km/h {16 mph}: 200-230 RPM 
 Inspect the VSS.
(See VEHICLE SPEED SENSOR (VSS) INSPECTION ).		 1J
SSA/SS1
(Shift solenoid A)		 %
  • 4GR: 99% 
  • others: 0% 
 Inspect the shift solenoid A.
(See SOLENOID VALVE INSPECTION ).		 1B
SSB/SS2
(Shift solenoid B)		 %
  • 1GR at D range. 99% 
  • Others: 0% 
 Inspect the shift solenoid B
(See SOLENOID VALVE INSPECTION ).		 1C
SSC/SS3
(Shift solenoid C)		 %
  • 1GR/2GR: 99% 
  • Others: 0% 
 Inspect the shift solenoid C.
(See SOLENOID VALVE INSPECTION ).		 1D
SSD/SS4
(Shift solenoid D)		 On/Off Idling
  • P, N position or D (4GR), M(1G or 4GR) range: On
  • Others: Off
 Inspect the shift solenoid D.
(See SOLENOID VALVE INSPECTION ).		 1E
SSE_SS5 (Shift solenoid E) On/Off
  • During TCC operation: On
  • Others: Off
 Inspect the shift solenoid E.
(See SOLENOID VALVE INSPECTION ).		 1F
TFT
(Transaxle fluid temperature)		 °C °F Indicates transaxle fluid temperature Inspect the TFT sensor.
(See TRANSAXLE FLUID TEMPERATURE (TFT) SENSOR INSPECTION ).		 1U
TFTV
(Transaxle fluid signal voltage)		 V
  • ATF 20 °C {68 °F}: 3.4-3.6 V 
  • ATF 130 °C {266 °F}: 0.4-0.5 V 
 Inspect the TFT sensor.
(See TRANSAXLE FLUID TEMPERATURE (TFT) SENSOR INSPECTION ).		 1U
THOP
(Throttle position sensor)		 %
  • CTP: 12% 
  • WOT: 75% 
 Inspect the TP sensor. (See THROTTLE POSITION (TP) SENSOR INSPECTION ). 2I, 2K
TR
(Transaxle range)		 P/R/N/D
  • P position: P
  • R position: R
  • N position: N
  • D range: D
 Inspect the TR switch.
(See TRANSAXLE RANGE (TR) SWITCH INSPECTION ).		 1S
TR_SENS
(TR switch)		 V
  • P position: 4.34-4.79 V 
  • R position: 3.83-4.18 V 
  • N position: 3.05-3.50 V 
  • D range: 2.23-2.66 V 
 Inspect the TR switch.
(See TRANSAXLE RANGE (TR) SWITCH INSPECTION ).		 1S
TSS
(Input/turbine speed)		 RPM Indicates Input/turbine speed
  • Ignition switch ON: 0 RPM 
  • Idle: 700-800 RPM  (P, N position)
 Inspect the input/turbine speed sensor.
(See INPUT/TURBINE SPEED SENSOR INSPECTION ).		 1M 1Q
UP SW
(Up switch)		 On/Off
  • M range, upshift: On
  • Other: Off
 Inspect the selector lever component.
(See SELECTOR LEVER COMPONENT INSPECTION ).		 1K
scientia non olet · About LEMON Manuals