DTC P0762: Notes

• When DTC P0731 and P0732 are not output, and both the following conditions are satisfied.
  • When all conditions below are satisfied while driving in 3GR.
    • ATF temperature 20 °C {68 °F} or more  .
    • Driving in D or M range
    • Engine running
    • Vehicle speed 19 km/h {12 mph} or more 
    • Turbine speed within 225-4,987 RPM 
    • Torque converter clutch (TCC) not operating
    • Differential gear case (output) revolution speed 35 RPM or more 
    • Revolution ratio of forward clutch drum revolution to differential gear case revolution within 1.404--1.704 
    • None of the following DTCs are present: P0706, P0707, P0708, P0712, P0713, P0715, P0720, P0751, P0752, P0753, P0756, P0757, P0758, P0761, P0762, P0763, P0766, P0767, P0768, P0771, P0772, P0773

Diagnostic support note: 

• This is a continuous monitor (CCM).
• The MIL illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
• The PENDING CODE is available if the PCM detects the above malfunction condition during the first drive cycle.
• FREEZE FRAME DATA is available.
• The AT warning light illuminates.
• The DTC is stored in the PCM memory.

• ATF level low
• Deteriorated ATF
• Shift solenoid C and pressure control solenoid stuck
• Control valve stuck
• PCM malfunction