DTC P0752: Notes

• When P0734 is not output, and all conditions below are satisfied in 1GR and 2GR.
  • ATF temperature 20 °C {68 °F} or more 
  • Engine running
  • D range selected
  • Brake pedal depressed
  • Closed accelerator position
  • Vehicle speed 0 km/h {0 mph} 
  • Input/turbine speed sensor signal 187.5 RPM or more  .
  • None of the following DTCs are present: P0706, P0707, P0708, P0712, P0713, P0715, P0720, P0751, P0752, P0753, P0756, P0757, P0758, P0761, P0762, P0763, P0766, P0767, P0768, P0771, P0772, P0773

Diagnostic support note: 

• This is a continuous monitor (CCM).
• The MIL illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
• The PENDING CODE is available if the PCM detects the above malfunction condition during the first drive cycle.
• FREEZE FRAME DATA is available.
• The AT warning light illuminates.
• The DTC is stored in the PCM memory.

• ATF level low
• Deteriorated ATF
• Shift solenoid A stuck
• Control valve stuck
• PCM malfunction