DTC P0711: Notes

• When all conditions below are satisfied.
  • When 180 s  have passed after the engine is started, vehicle is driven for 90 s or more  at vehicle speed between 25-59 km/h {15-36 mph}  , then 60 km/h {37 mph} or more for 60 s or more. 
  • P0712, P0713 not output
  • Variation in ATF voltage 0.03 V or less 
• When the detected ATF temperature is less than 20°C {68 °F}  together with the following conditions.
  • Intake air temperature is -7 °C {19.4 °F} or more  after engine starts.
  • Estimated ATF temperature is more than 55°C {131 °F}  while vehicle is driving.

Diagnostic support note: 

• This is a continuous monitor (CCM).
• The MIL illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
• The PENDING CODE is available if the PCM detects the above malfunction condition during the first drive cycle.
• FREEZE FRAME DATA is available.
• AT warning light does not illuminates.
• The DTC is stored in the PCM memory.

• TFT sensor malfunction
• Connector corrosion
• PCM malfunction