Neutral Switch Removal/Installation
WARNING: This page is about a different variant/trim than selected.
- Disconnect the negative battery cable.
- Remove the under cover.
- Disconnect the neutral switch connector.
- Remove the neutral switch.
- Install the neutral switch to the transaxle case.
Tightening torque
28.1-52.3 N.m {2.9-5.3 kgf.m, 20.8-38.5 ft.lbf}
- Clamp both the neutral switch and back-up light switch wiring harnesses as shown in the figure.
- Install the under cover.
- Connect the negative battery cable.