Cooling Pan Control System Inspection

Verify that the battery voltage is more than 12.4 V.
- If the battery voltage is less than 12.4 V, charge the battery or connect the external power supply.
Connect the M-MDS and access ECT PID.
Turn A/C switch to off.
Verify ECT PID is less than 98°C {209°F}.
- If ECT PID more than 98°C {209°F}, inspect ECT sensor and related wiring harnesses.
Verify that the cooling fan does not operate with ECT PID is less than 98°C {209°F} while the ignition switch is ON.
- If the cooling fan operates, inspect for following parts and related wiring harnesses:
  - ECT sensor
  - A/C switch
  - A/C refrigerant pressure switch (High/low pressure)
  - A/C refrigerant pressure switch (Medium pressure)
  - VSS
  - A/C magnetic clutch
  - Fan control signal circuit (between fan control module terminal B and PCM terminal 1W)
    - If the all items are normal, replace fan control module.
Verify the cooling fan operates while the A/C switch to ON with the ignition switch at ON position.
- If the cooling fan does not operate, inspect for following:
  - A/C switch
  - A/C refrigerant pressure switch (High/low pressure)
  - Fan control module power supply circuit
  - Fan control module GND circuit
  - Fan control signal circuit (between fan control module terminal B and PCM terminal 1W)
    - If the all items are normal, replace fan control module.

Verify that the cooling fan operates with following table.

COOLING FAN OPERATING REFERENCE

PCM terminal 1R voltage

B+ (off)*

0V (ON)*

Cooling fan speed

Middle speed

High speed

⁽¹⁾	A/C refrigerant pressure switch (Medium pressure) condition

If the cooling fan operation is not specified, inspect for following:
- A/C refrigerant pressure switch (Medium pressure)
  - If the A/C refrigerant pressure switch (Medium pressure) is normal, replace fan control module.