Section 3 (Engine Control System (L3 With TC))
WARNING: This page is about a different variant/trim than selected.
- Control System Component Location Index
- Control System Diagram
- Control System Wiring Diagram
- Pcm Removal/Installation
- Pcm Inspection
- Without Using the M-MDS
- Inspection Using An Oscilloscope (Reference)
- Fan control module signal
- HO2S (front) heater control signal
- CMP sensor signal
- CKP sensor signal
- Wastegate control solenoid valve signal
- Purge control signal
- OCV signal
- Generator field coil control signal
- Generator output voltage signal
- IGT1, IGT2, IGT3, IGT4 control signals
- Fuel injection control (-)
- Fuel injection control (+)
- Using the M-MDS
- Pcm Configuration
- Neutral Switch Inspection
- Clutch Pedal Position (CPP) Switch Inspection
- Power Steering Pressure (PSP) Switch Inspection
- Variable Swirl Shutter Valve Switch Inspection
- Engine Coolant Temperature (ECT) Sensor Removal/Installation
- Engine Coolant Temperature (ECT) Sensor Inspection
- Mass Air Flow (MAF) Sensor Inspection
- Intake Air Temperature (IAT) Sensor INSPECTI0N
- Manifold Absolute Pressure (Map) Sensor/Boost Air Temperature Sensor Removal/Installation
- Manifold Absolute Pressure (Map) Sensor Inspection
- Boost Air Temperature Sensor Inspection
- Throttle Position (TP) Sensor Inspection
- Accelerator Pedal Position (App) Sensor Inspection
- Fuel Pressure Sensor Removal/Installation
- Fuel Pressure Sensor Inspection
- Heated Oxygen Sensor (Ho2S) Inspection
- Heated Oxygen Sensor (Ho2S) Removal/Installation
- Crankshaft Position (CKP) Sensor Removal/Installation
- Crankshaft Position (CKP) Sensor Inspection
- Camshaft Position (CMP) Sensor Removal/Installation
- Camshaft Position (CMP) Sensor Inspection
- Knock Sensor (KS) Removal/Installation
- Knock Sensor (KS) Inspection
- Barometric Pressure (BARO) Sensor Inspection