Diagnostic procedure

DTC B2555 DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	INSPECT INTERIOR LIGHT AND MAP LIGHT CONNECTORS Turn the ignition switch off. Disconnect the interior light and map light connectors. Inspect the interior light and map light connector terminals for poor connection (such as damaged/pulled-out pins, and corrosion). Is there any malfunction?	Yes	Repair or replace the terminal, then go to Step 6.
1		No	Go to the next step.
2	INSPECT PJB CONNECTOR Disconnect the PJB connector. Inspect the PJB connector terminals for poor connection (such as damaged/pulled-out pins, and corrosion). Is there any malfunction?	Yes	Repair or replace the terminal, then go to Step 6.
2		No	Go to the next step.
3	INSPECT INTERIOR LIGHT AND MAP LIGHT CONTROL CIRCUIT FOR SHORT TO POWER SUPPLY Turn the ignition switch to the ON position (Engine off). Measure the voltage between PJB terminal J-05 U (wiring harness-side) and body GND. Is the voltage B+?	Yes	Repair or replace the wiring harness for a possible short to power supply, then go to Step 6.
3		No	Go to the next step.
4	INSPECT INTERIOR LIGHT AND MAP LIGHT CONTROL CIRCUIT FOR OPEN CIRCUIT Turn the ignition switch off. Inspect for continuity between following terminals: PJB terminal J-05 U (wiring harness-side) - interior light terminal C (wiring harness-side) PJB terminal J-05 U (wiring harness-side) - map light terminal C (wiring harness-side) Is there continuity?	Yes	Go to the next step.
4		No	Repair or replace the wiring harness for a possible open circuit, then go to Step 6.
5	INSPECT INTERIOR LIGHT AND MAP LIGHT Inspect the interior light and map light. (See INTERIOR LIGHT INSPECTION , MAP LIGHT INSPECTION .) Is there any malfunction?	Yes	Replace the interior light or map light, then go to the next step. (See INTERIOR LIGHT REMOVAL/INSTALLATION , MAP LIGHT REMOVAL/INSTALLATION .)
5		No	Go to the next step.
6	VERIFY TROUBLESHOOTING COMPLETED Make sure to reconnect all disconnected connectors. Clear the DTC from the PJB memory using the M-MDS. Perform the self-test. (See PJB SELF-TEST ). Is the same DTC present?	Yes	Replace the PJB. (See PASSENGER JUNCTION BOX (PJB) REMOVAL/INSTALLATION .)
6		No	DTC troubleshooting completed.