Keyless Control Module Removal/Installation

When replacing the keyless control module, perform the following procedure:
- KEYLESS CONTROL MODULE CONFIGURATION (See KEYLESS CONTROL MODULE CONFIGURATION .)
Disconnect the negative battery cable.
Remove the front side trim. (See FRONT SIDE TRIM REMOVAL/INSTALLATION. )
Remove the nut and screw.

Fig 1: Identifying Keyless Control Module, Nut & Screw
Courtesy of MAZDA MOTORS CORP.
Remove the connector clip installed to the bracket by shifting the keyless control module downward.
Disconnect the keyless control module connector.
Push the stopper with a small screwdriver and remove the bracket in the direction shown by the arrow.

Fig 2: Pushing Stopper With Small Screwdriver
Courtesy of MAZDA MOTORS CORP.
Install in the reverse order of removal.