LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2006 >> MPV LX >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic [Engine Control System (AJ)] >> DTC P1621 >> Diagnostic procedure

Diagnostic procedure

DTC P1621 [AJ] DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Check for related Service bulletins and/or online repair information availability.
  • Is any repair information available?
 Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
2 VERIFY DTC P1621 DETECTED AGAIN 
  • Clear the DTC from the memory using the WDS or equivalent.
  • Turn the ignition switch off, then start engine.
  • Is same DTC present?
 Yes Perform code word reprogram procedure.
(See IMMOBILIZER SYSTEM REPROGRAM PROCEDURE [CALIFORNIA EMISSION REGULATION APPLICABLE MODELS] .)
(See IMMOBILIZER SYSTEM REPROGRAM PROCEDURE [FEDERAL EMISSION REGULATION APPLICABLE MODELS] .)
No Go to the next step.
3 VERIFY TROUBLESHOOTING OF DTC P1621 COMPLETED 
  • Clear the DTC from the memory using the WDS or equivalent.
  • Turn the ignition switch off, then start engine.
  • Is same DTC present?
 Yes Replace PCM, then go to the next step.
No Go to the next step.
4 VERIFY AFTER REPAIR PROCEDURE  Yes Go to the applicable DTC inspection.
(See DTC TABLE .)
No Troubleshooting completed.
scientia non olet · About LEMON Manuals