LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2006 >> MPV ES >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Air Bag System >> Air Bag Module And Pre-TENSIONER Seat Belt Deployment Authorization Procedures [Standard Deployment Control System] >> After Replacing SAS Control Module

After Replacing SAS Control Module

  1. Install a new SAS control module.
    1. Turn the ignition switch to ON position.
    2. Verify that the air bag system warning light illuminates for approx. 6 s,  goes off, and then flashes continuously.
      • If the air bag system warning light does not flash continuously and indicates a DTC, inspect the system using the on-board diagnostic function. (See FOREWORD [STANDARD DEPLOYMENT CONTROL SYSTEM] or FOREWORD [TWO-STEP DEPLOYMENT CONTROL SYSTEM] .) When the malfunctions have been repaired and the air bag system warning light flashes continuously, turn the ignition switch to LOCK position. Wait for approx. 1 s or more  and then turn the ignition switch back to ON position.
      • If the air bag system warning light flashes continuously, turn the ignition switch to LOCK position. Wait for approx. 1 s or more  and then turn the ignition switch back to ON position.
  2. Verify that the air bag system warning light illuminates for approx. 6 s  and then goes off.
    • If the light stays on, perform the deployment authorization procedure again.
scientia non olet · About LEMON Manuals