LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2006 >> B3000 Base, Standard >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Wheel Speed Sensor - Front, 2WD >> Removal and Installation

Removal and Installation

  1. With the vehicle in NEUTRAL, position it on a hoist. See LIFTING .
  2. Disconnect the negative battery cable. See BATTERY DISCONNECT .
  3. Disconnect the wheel speed sensor electrical connector.
  4. Remove the wheel speed sensor harness bolt and unclip the retainers.
  5. Remove the wheel speed sensor bolt and the wheel speed sensor.
    • To install, tighten to 8 N-m (0.8 kgf-m, 71 in-lbf).
    NOTE:
    • Plug the sensor cavity and thoroughly clean the sensor mounting surface. Apply wheel bearing grease to the mounting surface.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals