LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2006 >> B3000 Base, Automatic >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Wheel Speed Sensor - Front, 4WD >> Removal and Installation

Removal and Installation

  1. Remove the brake disc shield. See BRAKE DISC SHIELD .
  2. Disconnect the negative battery cable. See BATTERY DISCONNECT .
  3. Disconnect the wheel speed sensor electrical connector.
  4. Remove the wheel speed sensor harness bolt and unclip the retainers.
    • To install, tighten to 8 N-m (0.8 kgf-m, 71 in-lbf).
  5. Remove the wheel speed sensor bolt and the wheel speed sensor.
    • To install, tighten to 12 N-m (1.2 kgf-m, 9 ft-lbf).
      NOTE:
      • Plug the sensor cavity and thoroughly clean the sensor mounting surface. Apply wheel bearing grease to the mounting surface.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals