Diagnostic Procedure

DTC P0446 DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	VERIFY FREEZE FRAME DATA AND DIAGNOSTIC MONITORING TEST RESULTS HAVE BEEN RECORDED Have FREEZE FRAME DATA and DIAGNOSTIC MONITORING TEST RESULTS (EVAP system related) been recorded?	Yes	Go to the next step.
1		No	Record FREEZE FRAME DATA and DIAGNOSTIC MONITORING TEST RESULTS on repair order, then go to the next step.
2	VERIFY RELATED REPAIR INFORMATION AVAILABILITY Check for related Service Bulletins and/or online repair information availability. Is any related repair information available?	Yes	Perform repair or diagnostic according to the. available repair information. If the vehicle is not repaired, then go to the next step.
2		No	Go to the next step.
3	CHECK COV CONTROL (EVAP SYSTEM LEAK DETECTION PUMP CIRCUIT FOR SHORT TO POWER) Turn ignition switch to ON (engine OFF). Disconnect the EVAP system leak detection pump connector. Measure the voltage between EVAP system leak detection pump connector terminal C (wiring harness-side) and body ground. Is the voltage B+ ?	Yes	Repair or replace the wiring harness, then go to Step 5.
3		No	Go to the next step.
4	INSPECT COV (EVAP SYSTEM LEAK DETECTION PUMP) Inspect the EVAP system leak detection pump. (See EVAPORATIVE EMISSION (EVAP) SYSTEM LEAK DETECTION PUMP INSPECTION [L3, AJ] ). Is the COV (EVAP system leak detection pump) normal?	Yes	Go to the next step.
4		No	Replace the EVAP system leak detection pump, then go to the next step.
5	VERIFY TROUBLESHOOTING OF DTC P0446 COMPLETED Make sure to reconnect all disconnected connectors. Turn the ignition switch to the ON position (Engine off). Clear the DTC from the PCM memory using the WDS or equivalent. Perform EVAP system test using the WDS or equivalent. (See EVAPORATIVE EMISSION (EVAP) SYSTEM LEAK INSPECTION ). Is same DTC present? NOTE: If EVAP system test function is not available, take following procedure. Perform "EVAP System Repair Verification Drive Mode". (See OBD-II DRIVE MODE ) Is the PENDING CODE for this DTC present?	Yes	Replace the PCM, then go to the next step.
5		No	Go to the next step.
6	VERIFY AFTER REPAIR PROCEDURE Perform "AFTER REPAIR PROCEDURE". (See AFTER REPAIR PROCEDURE ). Is any DTC present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE ).
6		No	Troubleshooting completed.