Diagnostic Procedure

DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	VERIFY FREEZE FRAME DATA AND DIAGNOSTIC MONITORING TEST RESULTS HAVE BEEN RECORDED Have FREEZE FRAME DATA and DIAGNOSTIC MONITORING TEST RESULTS (HO2S heater related) been recorded?	Yes	Go to the next step.
1		No	Record the FREEZE FRAME DATA and DIAGNOSTIC MONITORING TEST RESULTS on the repair order, then go to the next step.
2	VERIFY RELATED REPAIR INFORMATION AVAILABILITY Verify related Service Bulletins and/or on-line repair information availability. Is any related repair information available?	Yes	Perform the repair or diagnosis according to the available repair information. If the vehicle is not repaired, go to the next step.
2		No	Go to the next step.
3	INSPECT REAR HO2S TERMINAL Turn the ignition switch off. Disconnect the rear HO2S connector. Inspect for poor connection (such as damaged/pulled out pins, corrosion). Is there any malfunction?	Yes	Repair or replace the terminal, then go to Step 7.
3		No	Go to the next step.
4	INSPECT REAR HO2S HEATER Inspect rear HO2S heater. (See REAR HEATED OXYGEN SENSOR (HO2S) INSPECTION ). Is rear HO2S heater normal?	Yes	Go to the next step.
4		No	Replace the rear HO2S, then go to Step 7.
5	INSPECT PCM TERMINAL Disconnect the PCM connector. Inspect for poor connection (such as damaged/pulled-out pins, corrosion). Is there any malfunction?	Yes	Repair the terminal, then go to Step 7.
5		No	Go to the next step.
6	INSPECT REAR HO2S HEATER CONTROL CIRCUIT FOR SHORT TO POWER SUPPLY Turn the ignition switch to the ON position. (Engine off). Measure the voltage between rear HO2S terminal D and body ground. Is the voltage B+ ?	Yes	Repair or replace the wiring harness for shot to power circuit, then go to the next step.
6		No	Go to the next step.
7	VERIFY TROUBLESHOOTING OF DTC P0037 COMPLETED Make sure to reconnect all disconnected connectors. Clear the DTC from the PCM memory using the WDS or equivalent. Perform the KOEO self-test with WDS or equivalent, or HO2S heater, HO2S, and TWC Repair Verification Drive Mode. (See OBD-II DRIVE MODE ). Is the PENDING CODE for this DTC present?	Yes	Replace the PCM, then go to the next step. (See PCM REMOVAL/INSTALLATION ).
7		No	Go to the next step.
8	VERIFY AFTER REPAIR PROCEDURE Perform the "AFTER REPAIR PROCEDURE". (See AFTER REPAIR PROCEDURE ). Are any DTC present?	Yes	Go to the applicable DTC troubleshooting. (See DTC TABLE ).
8		No	Troubleshooting completed.