Steering Angle Adjustment
- Loosen the locknut of the tie-rod end.
- Remove the rack boot clamp.
- Rotate the tie rod and adjust the steering angle.NOTE:
- The travel distance of the right and left tie rods should be the same.
- Rotate the tie rod and adjust so that the difference between right and left dimension L shown in the figure is less than the specification.
Standard
3 mm {0.12 in} or less
- Tighten the locknut of the tie-rod end.
Tightening torque
78.6-108.0 N.m {8.02-11.01 kgf.m, 57.98-79.65 ft.lbf}
- Correct the rack boot twists.
- Install and fix the rack boot clamp.
- After adjusting the steering angle, always inspect and adjust the toe angle.