Resistance Inspection
- Turn the ignition switch to the LOCK position.
- Disconnect the negative battery cable.
- Disconnect the fuel injector connector.
- Inspect the resistance between fuel injector terminals A and B using a tester.
- If within the specification, perform the "Circuit Open/Short Inspection".
- If not within the specification, replace the fuel injector.
Fuel injector resistance
California emission regulation applicable model: 13.1-14.5 ohms [20 °C {68 °F}]
Except for California emission regulation applicable model: 11.4-12.6 ohms [20 °C {68 °F}]