Indicator Panel Assembly Note

Set the selector sleeve over the selector lever.
Grasp the O/D OFF switch wiring harness and pull it while pushing the selector lever knob down fully on the selector lever.
Connect the O/D OFF switch connector.
Shift the selector lever to the P position.
Align the alignment hole in the slider with the hole in the indicator panel. Install suitable heavy-gauge wire to hold the slider.
Tighten the indicator mounting screws in the order shown in the figure.
Tightening torque

1.5-2.4 N.m {16-24 kgf.cm, 14-21 in.lbf}

Fig 1: Installing Indicator Mounting Screws
Courtesy of MAZDA MOTORS CORP.
Remove the wire from the slider.

Fig 2: Installing Heavy-Gauge Wire & Slider
Courtesy of MAZDA MOTORS CORP.
Verify that the selector lever properly aligns with the indicator in each range.
Verify correct operation of the emergency override button.