Diagnostic procedure
DIAGNOSTIC PROCEDURE - DTC B2867
| STEP |
INSPECTION |
ACTION |
| 1 |
VERIFY THAT ALL SAS CONTROL MODULE CONNECTORS ARE CONNECTED WITH SAS CONTROL MODULE
WARNING:
- Handling the air bag system components improperly can accidentally deploy the air bag modules and pre-tensioner seat belts, which may seriously injure you. Read the service warnings and cautions before handling the air bag system components.
(See SERVICE WARNINGS
.)
(See SERVICE CAUTIONS
.)
- Turn the ignition switch to the LOCK position.
- Disconnect the negative battery cable and wait for 1 min or more
.
- Partially peel back the floor covering.
- Are all SAS control module connectors securely connected?
|
Yes |
Go to the next step. |
| No |
Reconnect the connector properly. |
| 2 |
INSPECT ALL SAS CONTROL MODULE CONNECTORS
- Remove the column cover.
- Disconnect the clock spring connector.
- Remove the glove compartment.
- Disconnect the passenger-side air bag module connector.
- Disconnect the driver and passenger-side side air bag module connectors.
- Disconnect the driver and passenger-side pre-tensioner seat belt connectors.
- Partially peel back the floor covering.
- Disconnect the SAS control module connector.
- Are the poor connection detector bars of SAS control module connectors normal?
|
Yes |
[Present malfunction diagnosis]
[Past malfunction diagnosis]
- DTC troubleshooting completed.
|
| No |
Replace the air bag wiring harness. |