Cruise Control Switch Wiring Harness Removal/Installation
- Remove cruise control switches. See CRUISE CONTROL SWITCH REMOVAL/INSTALLATION .
- Disconnect steering wheel wiring harness connector at right side of steering wheel attaching bolt.
- Remove steering wheel. See STEERING WHEEL REMOVAL/INSTALLATION .
- Disconnect wiring harness terminals from the two horn switches.
- Remove right horn switch.
- On back side of steering wheel, remove two screws and back cover.
- Disconnect wiring harness.NOTE:
- With steering wheel rim facing down on a bench, route wiring harness around steering wheel upper spokes to switch locations. Route wiring with black 5-pin air bag sliding contact connector from right cruise control switch through two retaining clips and through two wiring locating ribs beneath the right horn switch.
- Route horn switch wires as follows:
- Wire from the right cruise control switch to the left horn switch and the wire from the left cruise control switch to the right horn switch.
- Carefully route wiring between the locator posts and the top inside of the back cover.
- Install wiring harness in reverse order.
Tightening torque: Horn switch screws 6.5-7.5 N.m {0.66-0.76 kgf.m, 4.8-5.5 ft.lbf}