LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2005 >> B3000 Base, Automatic >> Repair and Diagnosis >> Steering >> Power Steering >> Power Steering System >> Inner Tie Rod >> Installation

Inner Tie Rod: Installation

  1. Lubricate the front wheel spindle tie-rod inner groove with steering gear grease where the front suspension steering ball stud boot seal is clamped.
    1. Check that the front suspension steering ball stud boot seal is positioned correctly over the steering gear housing bead at the large inside diameter (ID) and is in the front wheel spindle tie-rod groove at the small ID.
    2. Check that the front suspension steering ball stud boot seal is not twisted and the breather tube is securely inserted into the breather nipple at both front suspension steering ball stud boot seals.
  2. To install, reverse the removal procedure.
    Fig 1: Installing Inner Tie Rod
    G03730631Courtesy of MAZDA MOTORS CORP.
  3. Check the wheel alignment. Adjust as necessary. See WHEEL ALIGNMENT .
scientia non olet · About LEMON Manuals