Theft-Deterrent Control Module Inspection

1. Remove the theft-deterrent control module without disconnecting the connector.
2. Measure the voltage at the theft-deterrent control module terminals as indicated below.
3. Disconnect the theft-deterrent control module connector before inspecting for continuity at terminals B, N, O, P, and T.
4. If not as specified, inspect the parts listed under "Action."
   • If the parts and wiring harnesses are okay but the system still does not work properly, replace the theft-deterrent control module.

Fig 1: Theft-Deterrent Control Module Terminal Voltage Table (Reference) (1 Of 2)

Courtesy of MAZDA MOTORS CORP.

Fig 2: Theft-Deterrent Control Module Terminal Voltage Table (Reference) (2 Of 2)

Courtesy of MAZDA MOTORS CORP.