LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2005 >> 3 i, Standard >> Repair and Diagnosis >> Steering >> Power Steering >> Power Steering System >> Steering Gear And Linkage Assembly >> Mounting Rubber Assembly Note

Mounting Rubber Assembly Note

  1. Apply soapy water to the rubber part of the mounting rubber.
  2. Install the mounting rubber so that two notches of the mounting rubber are parallel to the steering rack.
  3. Press the mounting rubber until the mounting rubber end comes out completely from the gear housing using the SSTs  and a press.
    Fig 1: Pressing Mounting Rubber Into Gear Housing
    G03636656Courtesy of MAZDA MOTORS CORP.
  4. Reverse the gear housing, then press the mounting rubber until the mounting rubber end comes out completely from the other side. At this time, make sure that the mounting rubber and steel pipe are aligned.
    Fig 2: Pressing Mounting Rubber From Opposite Side Ensuring Proper Alignment
    G03636657Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals