Fuel Shut-Off Valve: Removal

Inspect that the quick release connector joint area is free of foreign materials. Clean as necessary.

Fig 1: Disconnecting Quick Release Connector
Courtesy of MAZDA MOTORS CORP.
Squeeze the tabs of the retainer and disconnect the quick release connector.
Cover the disconnected quick release connector and fuel pipe to prevent it from being scratch or contaminated with foreign materials.

Fig 2: Wrapping Disconnected Quick Release Connector & Fuel Pipe
Courtesy of MAZDA MOTORS CORP.
CAUTION:
- Removing the retainer from the disconnected fuel pipe will reduce the effectiveness of the retainer. The retainer must be replaced when any of the following applies.
  1. Retainer has been removed.
  2. Scratches or damage is observed on the retainer.
  3. Plastic fuel hose has been replaced.
  4. Fuel filter (high-pressure) has been replaced.
If removal of the retainer is required, remove it in the following procedure.

Fig 3: Removing Retainer
Courtesy of MAZDA MOTORS CORP.
CAUTION:
- Removing the retainer by using a tool can damage the fuel pipe and cause fuel leakage. Remove the retainer by opening the tabs outward by hand.
1. Open the tabs of the retainer outward.
2. Remove and discard the retainer.