LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2004 >> RX-8 1.3 3 >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Seat Belt System >> Lock Release Solenoid Inspection

Lock Release Solenoid Inspection

  1. Disconnect the negative battery cable.
  2. Remove the rear door lower trim. (See REAR DOOR LOWER TRIM REMOVAL/INSTALLATION .)
  3. Disconnect the lock release solenoid connector.
  4. Measure the resistance of the lock release solenoid individually.
    • If not within the specification, replace the front seat belt.

    Standard 54-66 ohms 

    Fig 1: Measuring Resistance Of The Lock Release Solenoid
    G01346291Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals