Indicator Panel Assembly Note

Set the selector sleeve over the selector lever.
Grasp the O/D OFF switch wiring harness and pull it while pushing the selector lever knob down fully on the selector lever.
Connect the O/D OFF switch connector.
Shift the selector lever to the P position.
Align the alignment hole in the slider with the hole in the indicator panel. Install suitable heavy-gauge wire to hold the slider.

Fig 1: Locating Slider & Heavy-Gauge Wire
Courtesy of MAZDA MOTORS CORP.
Tighten the indicator mounting screws in the order shown in the figure.
1. Tightening torque 1.5-2.4 N.m {16-24 kgf.cm, 14-21 in.lbf}
Remove the wire from the slider.

Fig 2: Tightening Sequence Of Indicator Mounting Screws
Courtesy of MAZDA MOTORS CORP.
Verify that the selector lever properly aligns with the indicator in each range.
Verify correct operation of the emergency override button.