LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2004 >> MX-5 Miata LS, Automatic >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Security System And Locks System >> Transmitter Battery Inspection

Transmitter Battery Inspection

CAUTION:
  • Since the battery voltage does not drop fully if the button is pushed for only 4 seconds or less, it can not be properly examined to see whether it is good or bad. Always push the button for 5 seconds.
NOTE:
  • Since a correct measurement cannot be obtained if the battery temperature is low, make sure the battery has been at 18 °C {64 °F} or more for at least 30 minutes before reinspecting when a measurement value is under the standard voltage.
  1. Remove the transmitter cover.
  2. Apply the circuit tester leads to the positions as indicated in the figure.
    Fig 1: Inspecting Transmitter Battery
    G00997315Courtesy of MAZDA MOTORS CORP.
  3. While pressing the battery as shown in the figure, press the LOCK and UNLOCK buttons on the transmitter at the same time to start measurement of the voltage.
  4. Release the buttons after 5 seconds  .
  5. Verify that the minimum voltage is the standard voltage or more for 10 seconds  after starting measurement.
    • If the voltage is under the standard voltage, replace the battery.
    1. Standard voltage 2.7 V 
    Fig 2: Measuring Transmitter Battery Voltage
    G00997316Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals