Assembly Procedure

Apply a coat of ATF to new seal ring and new O-ring, then install them onto piston.

Fig 1: Installing Seal Ring & O-Ring
Courtesy of MAZDA MOTORS CORP.

NOTE: After installing required parts to the piston, ensure that the piston rotates smoothly by hand. If not, the lip seal may be caught.

Apply a coat of ATF to inside of the drum, then install the piston while rotating it by hand.
Apply a coat of ATF to a new O-ring, then install it to the cancel force cover.
Position the return spring and cancel force cover.

CAUTION: Depress the spring retainer only enough to remove the snap ring. Overpressing will damage the retainer component edges.

Fig 2: Installing Snap Ring

Courtesy of MAZDA MOTORS CORP.

Install the SSTs in the clutch drum as shown.
Install the snap ring.
Remove the SSTs .
Install the dished plate, drive plates, and driven plates in the order as shown.

Fig 3: Installing Dished Plate, Drive & Driven Plates
Courtesy of MAZDA MOTORS CORP.
Install the retaining plate.
Install the snap ring.