LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2004 >> B4000 Base, Standard >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Interior Trim >> Instrument Panel Removal/Installation >> Installation Note

Installation Note

    NOTE:
    • Two technicians are required to perform this step.
  1. Position the instrument panel.
  2. Connect the instrument panel to main harness.
  3. Align and install the instrument panel.
  4. Install the left hand instrument panel cowl side bolts.
  5. Install the right hand instrument panel cowl side bolt.
  6. Install the instrument panel brace bolt.
  7. Connect the electrical connectors and the ground wires on the right hand cowl panel.
  8. Lower the glove compartment.
    • Press the glove compartment release tabs inward while pulling downward on the glove compartment.
  9. Connect the radio antenna cable in-line connector.
  10. Connect the climate control vacuum harness connector.
  11. Connect the blend door actuator connector.
  12. Install the passenger-side air bag module. See PASSENGER AIR BAG MODULE REMOVAL/INSTALLATION .
  13. Connect the air bag diagnostic monitor connector.
  14. Install the instrument panel valance panel.
  15. Position the bulkhead connector handle.
  16. Connect the brake pedal position (BPP) switch connector.
  17. Connect the clutch pedal position (CPP) switch connector.
  18. Install the bulkhead connector insulator.
  19. Install the bulkhead wiring harness connectors.
  20. Install the engine compartment fuse box onto the bracket.
  21. Install both front side trim panels.
  22. Install both A-pillar trim panels.
  23. Install the right hand and left hand scuff plates.
  24. Install the instrument panel fuse panel opening door.
  25. Install the parking brake release handle.
  26. Install the steering column. See STEERING COLUMN REMOVAL/INSTALLATION .
scientia non olet · About LEMON Manuals