LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2004 >> B4000 Base, Automatic >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Headlights >> Lighting System >> Multi-Function Switch Removal/Installation

Multi-Function Switch Removal/Installation

  1. Disconnect the negative battery cable.
  2. Remove the ignition lock cylinder. See IGNITION LOCK CYLINDER REMOVAL/INSTALLATION .
  3. If equipped, remove the tilt wheel handle.
  4. Remove the upper and lower steering column shrouds.
  5. Remove in order shown in figure.
    1. Screws
    2. Connectors
    3. Switch
  6. Install in reverse order of removal.
    1. Tightening torque 
      1. 2- 3 N.m (20 -31 kgf.cm, 18 -26 in.lbf) 
    Fig 1: Removing/Installing Multi-Function Switch
    G01935708Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals