LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2003 >> MX-5 Miata LS, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - Overhaul >> Automatic Transmission >> Automatic Transmission Assembly >> Precaution >> General Note

General Note

  1. If the drive plates are replaced with new ones, soak the new part in ATF for at least two hours before installation.
  2. Before assembly, apply ATF to all seal rings, rotating parts, O-rings, and sliding parts.
  3. All O-ring, seals, and gaskets must be replaced with the new ones included in the overhaul kit.
  4. Use petroleum jelly, not grease, during reassembly.
  5. When it is necessary to replace a bushing, replace the subassembly that includes that bushing.
  6. Assemble the housing within 10 minutes after applying sealant, and allow it to cure for at least 30 minutes after assembly before filling the transmission with ATF.
scientia non olet · About LEMON Manuals