Indicator Panel Adjustment

Shift the selector lever to the P position.
Loosen the indicator screws.
Align the alignment hole in the slider with the hole in the indicator panel. Install suitable heavy-gauge wire to hole the slider.

Fig 1: Installing Heavy-Gauge Wire Into Slider Hole
Courtesy of MAZDA MOTORS CORP.
Tighten the indicator mounting screws in the order shown in the figure.
Tightening torque
1. 1.5-2.4 N.m {16-24 kgf.cm, 14-21 in.lbf}
Fig 2: Indicator Mounting Screw Tightening Sequence
Courtesy of MAZDA MOTORS CORP.
Remove the wire from the slider.
Verify that the selector lever properly aligns with the indicator in each range.
Verify correct operation of the emergency override button.