DTC P0500: Vehicle Speed Sensor Circuit - Malfunction: Notes

With ABS/TCS -  Wheel speed signal from ABS/DSC HU/CM is less than 2.3 MPH when following conditions are met:

• Shift range in any position except P, N or R range (ATX)
• Neutral switch and clutch switch are off (MTX)
• Load is more than 40 percent
• Engine speed is 2000 RPM or more

ATX Without ABS/TCS -  Vehicle speed signal from TCM is incorrect. This is a Continuous Monitor (CM). MIL illuminates if PCM detects malfunction condition in two consecutive drive cycles or in one drive cycle while DTC for same malfunction has been stored in PCM. PENDING CODE is available if PCM detects malfunction condition during first drive cycle. FREEZE FRAME DATA is available. DTC is stored in PCM memory.

MTX Without ABS/TCS -  Vehicle speed signal from Vehicle Speed Sensor (VSS) is less than 2.3 MPH when following conditions are met:

• Neutral switch and clutch switch are off
• Load is more than 40 percent
• Engine speed is 2000 RPM or more