Theft-Deterrent Control Module Inspection

1. Remove the bracket without disconnecting the connectors.
2. Measure the voltage at the theft-deterrent control module terminals as indicated below.
3. Disconnect the theft-deterrent control module connector before inspecting for continuity at terminals B, N, O, P, and T.
   • If not as specified, inspect the parts listed under "Action".
   • If the parts and wiring harnesses are okay but the system still does not work properly, replace the theft-deterrent control module.

Fig 1: Identifying Theft Deterrent Control Module Connector Terminals

Courtesy of MAZDA MOTORS CORP.

Fig 2: Testing Theft Deterrent Control Module (1 Of 3)

Courtesy of MAZDA MOTORS CORP.

Fig 3: Testing Theft Deterrent Control Module (2 Of 3)

Courtesy of MAZDA MOTORS CORP.

Fig 4: Testing Theft Deterrent Control Module (3 Of 3)

Courtesy of MAZDA MOTORS CORP.