LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> B4000 Base, Standard >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Fender Front Removal/Installation >> Installation Note

Installation Note

  1. Install the front fender.
    • Install the bolts.
      1. Tightening Torque 
        1. 10-14 N.m {102-143 Kgf.cm, 8-10 ft.lbf} 
  2. If equipped, on the right hand front fender, install the cruise control servo.
    • Install the bolt.
      1. Tightening Torque 
        1. 9-12 N.m {92-122 Kgf.cm, 7-9 ft.lbf } 
  3. Install the grille opening panel reinforcement bolts.
    1. Tightening Torque 
      1. 6-8 N.m {61-82 Kgf.cm, 54-70 in.lbf} 
  4. Install the front fender to radiator support brace bolt.
    1. Tightening Torque 
      1. 10-14 N.m {102-143 Kgf.cm, 8-10 ft.lbf } 
  5. Install the radiator grille opening panel.
  6. Open the front door and install the front fender bolt.
    1. Tightening torque 
      1. 10-14 N.m {102-143 Kgf.cm, 8-10 ft.lbf } 
  7. Install the lower front fender to rocker panel bolt.
    • If required, install the fender spacer(s), maximum two each side.
      1. Tightening Torque 
        1. 10-14 N.m {102-143 Kgf.cm, 8-10 ft.lbf } 
  8. Install the front fender cowl side sound absorber.
    9. NOTE: Install the electrical connector locators into the proper positions.
    NOTE: On the right hand splash shield, connect the vacuum lines to the vacuum reservoir.
  9. Install the splash shield. See SPLASH SHIELD REMOVAL/INSTALLATION .
  10. If equipped, install the wheel splash guard.
  11. Install the parking lamp assembly. See PARKING LAMP ASSEMBLY REMOVAL/INSTALLATION .
  12. Install the front bumper. See FRONT BUMPER BRACKET REMOVAL/INSTALLATION .
scientia non olet · About LEMON Manuals