LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2001 >> B2500 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Generators & Regulators) >> System Tests >> Test G: Generator Is Noisy

Test G: Generator Is Noisy

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 Mazda B4000, 2003 Mazda B3000, 2003 Mazda B2300, 2002 Mazda B4000, and 2002 Mazda B3000. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For circuit and connector identification, see WIRING DIAGRAMS  and CONNECTOR IDENTIFICATION 
  1. Check accessory drive belt performance. Check pulleys and belt for looseness or misalignment. Repair as necessary, then retest system. If drive belt is okay, go to next step.
  2. Check generator mounting for loose bolts or misalignment. Adjust as necessary then retest system. If generator is securely mounted, go to next step.
  3. Disconnect generator connector A-168. Start engine, then turn headlights, rear defrost on, and run blower motor in HI speed. If noise is still present, then go to next step. If noise is not present, replace generator. See GENERATOR  under REMOVAL & INSTALLATION.
  4. Turn ignition switch to OFF position. Reconnect generator connector A-168, then start engine. Turn all accessories off. Use a stethoscope or similar listening device to probe generator for unusual noises. If generator is noise source, replace generator. See GENERATOR  under REMOVAL & INSTALLATION. If generator is not noise source, inspect other engine components for possible failure
scientia non olet · About LEMON Manuals