Multi-Function Switch Removal/Installation

WARNING: This page is about a different car, the 2002 Mazda B4000, 2002 Mazda B3000, and 2002 Mazda B2300. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Remove the ignition lock cylinder. See LOCK CYLINDER REMOVAL/INSTALLATION .
If equipped, remove the tilt wheel handle.
Remove the upper and lower steering column shrouds.
Remove in order shown in Fig 1 .
1. Screws
2. Connectors
3. Switch
Fig 1: Removing Multifunction Switch
Courtesy of MAZDA MOTORS CORP.
Install in reverse order of removal.
1. Tightening Torque
2. 2-3 N.m {20-31 kgf.cm, 18-26 in.lbf}