One Mirror Inoperative: 626
- Remove power mirror switch, leaving switch harness connector attached. See POWER MIRROR SWITCH under REMOVAL & INSTALLATION. Turn ignition switch to ACC position. Select appropriate mirror on power mirror switch. Using a voltmeter, backprobe terminal "F" at power mirror switch harness connector while pressing mirror switch to left or down position. See Figure . If battery voltage exists, go to next step. If battery voltage does not exist, replace power mirror switch.
- Access appropriate power mirror harness connector (it may be necessary to remove door trim panel). See POWER MIRROR ASSEMBLY under REMOVAL & INSTALLATION. Ensure ignition switch is in ACC position. Using voltmeter, backprobe terminal "D" at power mirror harness connector while pressing mirror switch to left or down position. See Figure . If battery voltage exists, replace appropriate mirror. If battery voltage does not exist, repair wiring between power mirror and power mirror switch. See WIRING DIAGRAMS .