Airflow Mode Inoperative
WARNING: This page is about a different car, the 1997 Mazda MX-6 and 1997 Mazda 626. However, it is still accessible from the selected car via links, so may be relevant.
Test airflow mode actuator. See ACTUATORS . If actuator is okay, disconnect airflow mode actuator connector and heater control panel connector. Check continuity of wiring harness between control panel connector and airflow mode actuator connector. See AIRFLOW MODE ACTUATOR WIRING HARNESS TEST table. If continuity is as specified, replace heater control panel. If continuity is not as specified, repair appropriate open wire between connectors.
AIRFLOW MODE ACTUATOR WIRING HARNESS TEST
| Terminal Wire Color (1) | Continuity | ||
|---|---|---|---|
| White | Yes | ||
| White/Black | Yes | ||
| White/Yellow | Yes | ||
| White/Green | Yes | ||
| White/Blue | Yes | ||
| Yellow | Yes | ||
| Yellow/White | Yes | ||
| Yellow/Black | Yes | ||
| Yellow/Green | Yes | ||
|
|||