LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1998 >> 626 ES, Automatic >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Fuel System >> Fuel System Pressure Release >> Except B2500, B3000 & B4000

Except B2500, B3000 & B4000

  1. Start engine. On Millenia, MPV and 626, disconnect fuel pump relay. See FUEL PUMP RELAY LOCATION  table.
  2. On Protege, disconnect fuel pump connector near fuel tank (fuel pump connector is accessible from under rear seat cushion).
  3. On all models, allow engine to run until it stalls. Turn ignition off. Reconnect electrical connector.
FUEL PUMP RELAY LOCATION

Application Location
Millenia 2.5L & 626 Underhood Relay Panel.
Millenia 2.3L Beside Cruise Control Actuator.
MPV Below Right Side Floor Board, Beside PCM.